Setup and Config
Getting and Creating Projects
Branching and Merging
Sharing and Updating Projects
Inspection and Comparison
gitworkflows(7) Manual Page
gitworkflows - An overview of recommended workflows with git
This document attempts to write down and motivate some of the workflow elements used for git.git itself. Many ideas apply in general, though the full workflow is rarely required for smaller projects with fewer people involved.
We formulate a set of rules for quick reference, while the prose tries to motivate each of them. Do not always take them literally; you should value good reasons for your actions higher than manpages such as this one.
As a general rule, you should try to split your changes into small logical steps, and commit each of them. They should be consistent, working independently of any later commits, pass the test suite, etc. This makes the review process much easier, and the history much more useful for later inspection and analysis, for example with git-blame(1) and git-bisect(1).
To achieve this, try to split your work into small steps from the very beginning. It is always easier to squash a few commits together than to split one big commit into several. Don't be afraid of making too small or imperfect steps along the way. You can always go back later and edit the commits with git rebase --interactive before you publish them. You can use git stash save --keep-index to run the test suite independent of other uncommitted changes; see the EXAMPLES section of git-stash(1).
Merges have many advantages, so we try to solve as many problems as possible with merges alone. Cherry-picking is still occasionally useful; see "Merging upwards" below for an example.
Most importantly, merging works at the branch level, while cherry-picking works at the commit level. This means that a merge can carry over the changes from 1, 10, or 1000 commits with equal ease, which in turn means the workflow scales much better to a large number of contributors (and contributions). Merges are also easier to understand because a merge commit is a "promise" that all changes from all its parents are now included.
There is a tradeoff of course: merges require a more careful branch management. The following subsections discuss the important points.
As a given feature goes from experimental to stable, it also "graduates" between the corresponding branches of the software. git.git uses the following integration branches:
maint tracks the commits that should go into the next "maintenance release", i.e., update of the last released stable version;
master tracks the commits that should go into the next release;
next is intended as a testing branch for topics being tested for stability for master.
There is a fourth official branch that is used slightly differently:
pu (proposed updates) is an integration branch for things that are not quite ready for inclusion yet (see "Integration Branches" below).
Each of the four branches is usually a direct descendant of the one above it.
Conceptually, the feature enters at an unstable branch (usually next or pu), and "graduates" to master for the next release once it is considered stable enough.
The "downwards graduation" discussed above cannot be done by actually merging downwards, however, since that would merge all changes on the unstable branch into the stable one. Hence the following:
Always commit your fixes to the oldest supported branch that require them. Then (periodically) merge the integration branches upwards into each